Skip to content Skip to navigation Skip to footer
POLARIS OFF-ROAD VEHICLES

HELP CENTER

2020-06-06
VIDEO: Phoenix 200 Pre-Ride Inspection

Before you ride your Polaris Phoenix 200, perform the pre-ride inspection as described in your Owner’s Manual. Read, understand and follow all of the instructions, warnings and safety precautions in the Owner’s Manual and on all product labels. Failure to follow these instructions, warnings and safety precautions could result in serious injury or death.

During your pre-ride inspection, do the following:

1. Visually inspect the vehicle, looking for debris, leaks and worn components that may impair the vehicle’s operation.

2. Check the condition of the tires, looking for any sign of punctures or damage, and check tread depth.

3. Check the tire pressures and verify that they are to specification. The tire pressure should be 4 psi (28 kPa) on all tires.

4. Inspect the suspension and brakes for leaks, debris and damage.

5. Remove the seat and inspect the battery cables for tightness.

6. Also inspect the intake system for blockage or debris, and clean as needed. Notice: DO NOT spray water directly into the intake system, as this can result in water intrusion to the engine.

7. Next, inspect the engine oil level. Notice: Ensure the vehicle is on a level surface in a well-ventilated area.

  • Start the vehicle for 1 to 2 minutes.
  • Stop the engine.
  • Remove the oil dipstick and wipe with a clean shop towel.
  • Reinstall the oil dipstick fully and remove to inspect the oil level. Caution: Operating with insufficient, deteriorated or contaminated engine oil will cause accelerated wear and may result in engine or transmission seizure, which could result in loss of control and serious injury or death.
  • Add oil as needed. Caution: Do not overfill. Overfilling can result in loss of engine performance and an oil-saturated air filter. Use a suction device to remove excess oil if overfilled.

8. Inspect the fuel level and add fuel as needed.

9. Turn the key on and inspect the headlights, taillights and brake lights for proper operation.

10. Check the steering for smooth operation from full left to full right.

11. Operate the throttle and brake levers, taking note of any binding or sticking.

12. Start the engine and verify the low oil pressure light is not illuminated.

13. Operate the horn and ensure it sounds loudly.

14. Stop the engine with the engine run/stop switch and ensure the engine does not restart.

For more information, see your authorized Polaris Dealer. Find a dealer near you through the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

Keyword(s) video , maintenance , check , inspect , youth