To update the maps on your 4.3-inch Polaris Interactive Digital Display:
1. Go to the Ride Command website.
2. Scroll to the very bottom of the page and click on UPDATE VEHICLE SOFTWARE.
3. Select the 4.3-inch Off-Road Display.
4. Select first your hemisphere and then your region/country.
5. If this is the first time you're updating your display, select the COMPLETE MAP option. If you've updated your display before, select SOFTWARE MAP AND TRAILS.
6. Once downloaded, copy the files to a USB Drive by opening your computer's Downloads folder and double clicking the zipped folder to extract all the files.
- If you downloaded Trails Only, there will be three files to extract as shown below.
- If you downloaded Complete Map, there will be four files to extract.
- Your USB Drive must be a 4, 6 or 8 gigabyte USB Drive.
- The USB Drive must be formatted to the FAT32 file system.
- If the display reads "Update file not found," your USB Drive may be formatted incorrectly.
- Only the update files should be copied to the USB Drive, not the zipped folder.
7. Connect the USB Drive to the USB connector on your vehicle. On side-by-side vehicles, the USB connector is located in your glovebox. On ATVs, the USB connector is located on the front side of the right handlebar controls.
8. Once the USB Drive is connected to the USB connector on your vehicle, turn the vehicle key to the accessory/run position. Now you can complete the update by using your display. Below is an overview of your displays buttons to assist you.
- Press Key 3 twice to open the Menu.
- Press Key 4 to scroll down to System Settings.
- Press Key 3 to select System Settings.
- Press Key 4 to scroll down to System Info.
- Press Key 5 twice to select Update.
9. The following Restart screen will appear if the files are found. Press Key 3 to Accept.
Note: If the following screen appears instead of the Restart screen above, reset the USB drive and make sure the map files are not in a folder on the USB drive. Only update files should be on the USB drive, with no other files or folders.
10. After you've accepted "Would you like to restart in bootloader mode?", your display screen will go black and then show text indicating that the display is restarting.
11. You will be prompted by the warning: WARNING: Maps/Trails are supplied as an aid and should not be used for any purpose requiring precise measurement of direction, distance, or location. Polaris makes no warranty as to the accuracy or completeness of this map data. Press Key 3 to accept.
12. Press Key 5 two times to continue. The right arrow will turn green as shown below:
13. Wait for the download process to complete. Update duration will vary. Do not turn off the key while the update is downloading. The Trails Only update will take approximately 10 minutes. The Complete Map update will take approximately 35 minutes.
14. The display will restart itself once the download is complete. Turn the key to the off position, then you can remove the USB Drive.
Trails expire 90 days from their release date. When trails expire, a red warning bar will alert the rider that the trails are expired. The trails will still be visible after pressing Key 3 to accept the warning.
To learn more about the Polaris Interactive Digital Display, consult the User's Guide.